www.intI-bornsun.com

Home    导热材料    导热硅脂    BN-G600

BN-G600

  • Benefits and Features
    Thermal conductivity: 5.5W/m·K
    Excellent thermal performance
    Good reliability
    Superior ability to flow and conform to interfaces
    Excellent thermal resistance 
    Non-toxic, non-corrosive

     

    Bornsun’s thermal grease
    Thermal greases (also called thermal compound or thermal paste) are thermally conductive. 
    Amongst the various thermal interface materials, thermal greases typically offer better thermal performance, acting as an important role in the thermal management. In addition, thermal contacts made using thermal greases can be reworked, allowing easy repair and upgrade.
    The BN-G600 of low viscosity has the ability to flow and conform to interfaces, providing a path of low thermal resistance between the heat generating devices and the heat spreaders/sinks. This leads to higher effective thermal conductivity, helping to dissipate the heat to heat sinks effectively. 

      

    Typical Application                                   
    ● Between a semiconductor and heat sink
    ● Between a CPU and heat sink                        
    ● Between a power supply resistor and base
    ● Thermoelectric cooling device
    ● Temperature regulator
            
    Packaging Description
    Thermal Grease BN-G600 is available in:
    Syringes;
    Bulk;
    Custom Sizes Available.

     

    Storage Conditions: 
    Store at room temperature,
    Avoid sunlight exposure
    Humidity < 60%.

     

    Application of thermal grease  
    For small volume applications:
    Pre-clean heat sink/spreader and component interfaces
    Mix well before using
    Apply a small drop of thermal grease on the top of the component
    Make sure it’s a uniform coating thickness across the thermal substrate
    For large volume applications: silk screening is recommended
    Silk Screening:
    Place heat sink approximately 2.5 mm under the taut silk screen.
    Apply a dollop of thermal grease across one side of the screen.
    Run a hard rubber (70 – 80 Shore A) squeegee across the dollop passing across the screen. Turn it over to pass the screened grease a second time with the clean side of the squeegee.
    Lift off the screen to reveal the printed grease.
    Repeat if necessary.
    Remove the stencil to reveal the printed grease.